tag:blogger.com,1999:blog-3202997046982522098.post5275921856100628207..comments2023-07-19T09:28:26.805-06:00Comments on nolebotic: Robots: Micro-Masetro HexapodMatthewhttp://www.blogger.com/profile/11258503672528061078noreply@blogger.comBlogger2125tag:blogger.com,1999:blog-3202997046982522098.post-4072482589220477922014-02-22T09:50:44.149-06:002014-02-22T09:50:44.149-06:00Hello Albireo, and thanks for your comment. The t...Hello Albireo, and thanks for your comment. The technique you ask about was very simple yet highly effective. Take your steel wire leg and roughen up the surface with sandpaper or nail file. Hold the leg in position against the servo arm and simply wrap it as tightly as you can with thread. Polyester/synthetic type thread will be a lot stronger than cotton. Once it's wrapped put a few drops of super glue on it (CA type glue, which stands for cyanoacrylete). After it dries you will have a strong bond. Here's a close up of mine: http://imgur.com/Lw9jlUk Matthewhttps://www.blogger.com/profile/11258503672528061078noreply@blogger.comtag:blogger.com,1999:blog-3202997046982522098.post-49322316586655328342014-02-22T01:06:46.989-06:002014-02-22T01:06:46.989-06:00You mentioned using poly thread and CA glue to con...You mentioned using poly thread and CA glue to connect the wire legs to the servo horns. Can you elaborate on the technique you used? Albireohttps://www.blogger.com/profile/09577701372888794817noreply@blogger.com